glc40 commercial ac input 90-264 vac, 47-63 hz single phase. input current maximum input current at 120 vac, 60 hz with full rated output load not to exceed 1.3 a. output power normal continuous output power is 40 w for unrestricted natural convec - tion cooling, 45 w peak for 60 seconds. during peak load conditions output regulation may exceed total regulation and noise limits. output regulation regulation for multiple-output models measured by 40% load change from 60% rated load with all other outputs at 60% full rated load and a line volt - age change from low line to high line. initial set tolerance is measured with all outputs at 60% of full rated load. output voltage v1 requires 1 a load for proper regulation of multiple output models. regulation for single-output models measured by changing from 5% to 50% load or 50% load to full load in either direction. power limit factory set to begin power limiting at approximately 55 w. fully protected against short circuit and output overload. short circuit protection is cycling type power limit. output noise 0.5% rms, 1% pk-pk, 20 mhz bandwidth, mode. measured with noise probe terminals of the power supply. transient response main output: 500 s typical response time for return to within 0.5% of fnal value for a 50% load step change, ?i/ ?t<0.2 a/s. maximum voltage devia - tion is 3.5%. startup/ shutdown overshoot less than 3%. overvoltage protection built in on v1 with fring point set per table. ovp fring reduces output #1 and #2 to less than 50% of nominal voltage in 50 ms. 40 watt global performance low cost switchers ? cost-efective power source ? universal input 90-264 vac ? 2-year warranty ? single and multiple outputs ? overload and overvoltage protection ? built-in emi flter ? ul1950, csa-c22.2 no. 234 level 3, iec950 and en60950 ? operation at no-load (single output models) ? rohs compliant (with g sufx) global performance switchers all specifcations are typical at nominal input, full load at 25 o c unless otherwise stated features: specifications ? marked to lvd voltage setting factory set on standard units with fxed resistors for added reliability. 3.3 v unit has voltage adjustment pot. efciency 70% typical depending on model. turn-on time less than 1 second at 120 vac, 25c (inversely proportional to input voltage and thermistor temperature). input protection internal ac fuse provided on all units. designed to blow only if a catastrophic failure occurs in the unit. fuse does not blow on overload or short circuit. inrush current inrush limited by internal thermistors. inrush at 240 vac, averaged over the frst ac half-cycle under cold start conditions will not exceed 37 a. temperature coefcient 0.03%/c typical on all outputs. emi/emc compliance all models include built-in emi fltering to meet the following emissions requirements: emi specifications compliance level conducted emissions static discharge rf field susceptibility fast transients/bursts surge susceptibility en55022 class a; fcc class a en61000-4-2, 6 kv contact, 8 kv air en61000-4-3, 3 v/meter en61000-4-4, 2 kv, 5 khz en61000-4-5, 1 kv dif., 2 kv com. safety all glc40 models are approved to ul1950, csa-c22.2 no. 234 level 3, iec950 and en60950. class i input.
commercial model output no. output output minimum output maximum v 1 ovp set noise p-p total regulation glc40ag 1 + 5.1 v 1 a 3 a + 6.2 0.6 v 50 mv 2% 2 + 12 v 0 a 2 a 120 mv 6% 3 - 12 v 0 a 0.4 a 120 mv 5% glc40bg 1 + 5.1 v 1 a 3 a + 6.2 0.6 v 50 mv 2% 2 + 15 v 0 a 1.5 a 150 mv 6% 3 - 15 v 0 a 0.4 a 150 mv 5% glc40dg 1 +5 v 1 a 3 a + 6.2 0.6 v 50 mv 2% 2 +24 v 0 a 1 a 240 mv 6% 3 -12 v 0 a 0.4 a 120 mv 5% glc40-3.3g 1 3.3 v 0 a 8 a 4.2 0.6 v 33 mv 2% glc40-5g 1 5 v 0 a 8 a 6.2 0.6 v 50 mv 2% glc40-9g 1 9 v 0 a 4.4 a 11 0.9 v 90 mv 2% glc40-12g 1 12 v 0 a 3.3 a 14 1.1 v 120 mv 2% glc40-13.8g 1 13.8 v 0 a 2.9 a 17.7 +/- 1.5 v 138 mv 2% glc40-15g 1 15 v 0 a 2.7 a 18.5 1.5 v 150 mv 2% glc40-24g 1 24 v 0 a 1.7 a 28.5 2.5 v 240 mv 2% glc40-28g 1 28 v 0 a 1.4 a 34 2.8 v 280 mv 2% sl power electronics, inc. 6050 king drive, bldg. a, ventura, ca, 93003, usa. phone:(805) 486 4565 fax:(805) 487 8911 email: info@slpower.com . rev. 10/09. data sheet ? 2009 sl power electronics, inc. the information and specifcations contained in this data sheet are believed to be correct at time of publication. however, sl power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. specifcations are subject to change without notice. glc40 mechanical specifications
|
